Rms-technologies IMD23 W/ POLE DAMPING TECHNOLOGY Instrukcja Użytkownika Pobierz pdf (Strona 13)

RMS Technologies Page 13 Version 1.10

IMD23/23DE Manual 12/3/2007

Configuring Settings using Configuration Module (for new RoHS products)

Default Settings of the IMD23 or DE

Direction of rotation Counterclockwise

Disable Power On – motor power is disabled

when disabling unit

Step Resolution 8x step (3200 steps/rev)

Run Current Motor’s rated current or up to

3 Amps Peak if motor is rated

for 3 or higher.

Holding Current 25% of motor’s rated Current

Damping Mode 37% damping

Step signal sensing Senses on the Falling edge or

Negative edge

Direction signal

sensing

Senses on the Falling edge or

Negative edge

How to Connect the Configuration Module

Align configuration module and small adapter board in the following orientation, and insert

ribbon cable without twisting the cable:

Instructions on Using the Configuration Module

1. Power Off the power supply and Opto Supply and disconnect or power off any step,

direction, and disable/enable signals. If using the internal opto supply, disconnect it.

2. Set all the DIP switches on the Config Module to the required positions

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 22 23

Brak uwag

Rms-technologies IMD23 W/ POLE DAMPING TECHNOLOGY Instrukcja Użytkownika Strona 13